Washing And Drying - Victory V92TC Owner's Manual

Cleaning and Storage

Washing and Drying

Before washing the motorcycle, make sure the exhaust pipes are not hot. Cover each exhaust pipe opening
with a plastic bag and attach the bag to the pipe with a strong rubber band. To prevent contamination from
water, check that the spark plugs, spark plug wire caps, oil fill cap, and fuel caps are properly seated.
1. Park the motorcycle in the shade to prevent water spotting.
2. The engine cases are painted. If you choose to use a degreaser, follow the degreaser manufacturer's
instructions.
3. Rinse off as much dirt and mud as possible with water running at low pressure.
Caution
• Do not use high water pressure or high- -pressure sprayers such as those found at coin- -operated car
washes. Excessive water pressure may allow water to seep into and deteriorate such components as
wheel bearings, brake caliper assemblies, brake master cylinders, and transmission seals.
• Electrical components may be damaged by contact with water. Do not spray or allow water to come
into contact with electrical components or connectors.
4. Wash the entire motorcycle using a soft cloth or sponge soaked in a solution of mild detergent and
warm water, applying minimal pressure as you wash. Let the detergent do the cleaning, not the
pressure you apply. Excessive washing pressure may cause dirt, sand, or other foreign materials on
the motorcycle to scratch the finish. Keep the cloth or sponge clean by rinsing it frequently, and soak
it in the detergent and water solution to provide plenty of soapy water for washing. A toothbrush or
bottlebrush can help you wash places that are difficult to reach with a cloth or a sponge.
116