Assembly - Porter-Cable 3700L Instruction Manual

UNPACKING AND CLEANING
1. Carefully remove the machine from the carton. Retain all packing materials until you have inspected and satisfactorily
operated the machine.
Do not operate this machine until you read and understand the entire instruction manual.
2. Place the machine on a firm, level surface with extra room for handling and proper support of the workpiece.
3. Familiarize yourself with all features and controls explained in this manual.
4. The machine is shipped with the cuttinghead locked in the down position and the table rotated to 45° left. To release the
head and move it to the operating position, see "MOVING CUTTINGHEAD TO THE UP POSITION" and "MOVING THE
TABLE TO THE 0° CUT-OFF POSITION" in this manual.
Arbor and fence wrench (supplied)
3mm Hex wrench (supplied)
1/8" Hex Wrench (supplied)
MOVING THE CUTTINGHEAD TO THE "UP" POSITION
Pull out the cuttinghead lockpin (A) Fig. 1, and move the cuttinghead (B) to the "UP" position. Fig. 2 shows a close-up of the
lockpin (A) pulled out and the cuttinghead (B) in the "UP" position.
Fig. 1
MOVING TABLE TO THE 0° CUT-OFF POSITION
1. Rotate the locking knob (A) Fig. 3 counter-clockwise.
Lift the lever (B) and rotate the table (C) to the 0° straight
cut-off position, release the lever (B), and tighten the
locking knob (A).
2. For proper operation and adjustment of the table,
refer to sections, "ROTATING TABLE FOR MITER
CUTTING", and "ADJUSTING SLIDING FIT BE-
TWEEN MOVABLE TABLE AND BASE."

ASSEMBLY

ASSEMBLY TOOLS REQUIRED
ASSEMBLY TIME ESTIMATE
Assembly time for this unit is approximately 30 minutes.
B A
5mm Hex Wrench (Supplied)
Phillips Screwdriver
3 AA Batteries (Not Supplied)
B
Fig. 2
C
B
8
A
A
Fig. 3