03
Connecting your equipment
Connecting an iPod
This receiver has a dedicated iPod terminal that will allow
you to control playback of audio content from your iPod
using the controls of this receiver.
•
Switch the receiver into standby then use the
supplied iPod cable to connect your iPod to the iPod/
iPhone/USB terminal on the front panel of this receiver.
• Push down on the PUSH OPEN tab to access the
iPod/iPhone/USB terminal.
• It is also possible to connect using the cable included
with the iPod, but in this case it is not possible to view
pictures via the receiver.
• For the cable connection, refer to also the operating
instructions for iPod.
• For instructions on playing the iPod, see Playing an
iPod on page 44.
CONTROL
MCACC SETUP MIC
iPod cable
(supplied)
36
En
ON / OFF
VIDEO CAMERA
iPod
iPhone
USB
HDMI 4
This receiver
MENU
iPod
Connecting a USB device
It is possible to playback files using the USB interface on
the front of this receiver.
•
Switch the receiver into standby then connect your
USB device to the USB terminal on the front panel of
this receiver.
• Push down on the PUSH OPEN tab to access the USB
terminal.
• For instructions on playing the USB device, see
Playing a USB device on page 46.
MCACC SETUP MIC
MASTER
VOLUME
CONTROL
ON / OFF
VIDEO CAMERA
iPod
iPhone
USB
HDMI 4
This receiver
USB mass
storage device
MASTER
VOLUME