Pioneer VSX-LX52 Operating Instructions Manual page 63

Using other functions
Setting What it does
Specifies the aspect ratio when
b
ASP
analog video input signals are
(Aspect)
output at the HDMI output. Make
your desired settings while
checking each setting on your
display (if the image doesn't match
your monitor type, cropping or
black bands appear).
c,d This setting optimizes the picture
PCINEMA
for film material when the video
,e
output is set to progressive.
(PureCinema)
Usually set to AUTO; but try
switching to OFF if the picture
appears unnatural.
Additionally, certain PAL movie
video (576i, 25 frames/second STB
video output or DVD disc playback,
etc.) that contain film progressive
material cannot be recognized as
such by this receiver. In such
instances, if you choose PAL,
PureCinema mode is activated.
c, Adjusts the motion and still picture
P.MOTION
quality when video output is
e
(Progressive progressive.
Motion)
c Adjusts the amount of noise
YNR
reduction (NR) applied to the Y
(brightness) component.
c Adjusts how sharp edges appear.
DETAIL
c,f Adjusts the sharpness of the high-
SHARP
frequency (detailed) elements in
(Sharpness)
the picture.
Adjusts the overall brightness.
c
BRIGHT
(Brightness)
Adjusts the contrast between light
CONTRAST
and dark.
c
c,g Adjusts the red/green balance.
HUE
Adjusts saturation from dull to
c
CHROMA
bright.
(Chroma
Level)
a.• When set to a resolution with which the TV (monitor) is not
compatible, no picture is output. Also, in some cases no picture will
be output due to copyright protection signals. In this case, change
the setting.
• When AUTO is selected, the resolution is selected automatically
according to the capacity of the TV (monitor) connected by HDMI.
When PURE is selected, the signals are output with the same
resolution as when input (At this time, video signals are only output
from the same type of terminals to which they were input).
• When a display is connected by HDMI, if this is set to something
other than PURE and 480i/576i analog signals are input, 480p/576p
signals are output from the component output terminals.
• Conversion to 1080p is only performed for 480i, 576i, 480p and
576p input signals.
b.• If the image doesn't match your monitor type, adjust the aspect
Option(s)
ratio on the source component or on the monitor.
THROUGH
• This cannot be set when the resolution is set to PURE.
• NORMAL setting is only displayed when 480i/p or 576i/p video
NORMAL
signals are being input.
c.This setting is only displayed when 480i or 576i video signals are
being input.
d.If the picture does not display properly when PAL is selected, select
AUTO or OFF.
e.This setting is only valid for component outputs.
f. This setting is not valid for HDMI output(s).
g.This setting is not displayed for component inputs.
AUTO
PAL
OFF
–4 to +4
set to
Default: 0
0 to +8
Default: 0
–4 to +4
Default: 0
–4 to +4
Default: 0
–6 to +6
Default: 0
–6 to +6
Default: 0
–6 to +6
Default: 0
–6 to +6
Default: 0
08
63
En