Care And Cleaning; Troubleshooting - Electrolux EHI845BA User Manual

12

CARE AND CLEANING

Clean the appliance after each use.
always use cookware with clean bottom.
Scratches or dark stains on the glass ceramic have no effect
on how the appliance operates.
To remove the dirt
1. remove immediately: melted plastic, plastic foil, and
food with sugar. If not, the dirt can cause damage to
the appliance. Use a special scraper for the glass. Put
the scraper on the glass surface at an acute angle and
move the blade on the surface.
remove after the appliance is sufficiently cool:
limescale rings, water rings, fat, stains, shiny metallic
discolourations. Use a special cleaning agent for glass
ceramic or stainless steel.
2. Clean the appliance with a moist cloth and some
detergent.
3. At the end rub the appliance dry with a clean cloth.

TROUBLESHOOTING

Problem
Red rings, limescale or water
rings, shiny metallic or other
discolouration, scratches/
shadows, bubbles or other
miscellaneous marks or stains on
ceramic glass cooktop surface.
Pitting of ceramic glass surface.
You cannot activate the
appliance or operate it.
An acoustic signal sounds and
the appliance deactivates. An
acoustic signal sounds when
the appliance is deactivated.
The appliance deactivates.
The residual heat indicator does
not come on.
The Automatic Heat Up function
does not operate.
The heat setting changes
between two levels.
Possible cause
Cooktop surface has not been cleaned
correctly. Cleaning/ maintenance of the
cooktop surface is not covered under
warranty. If a service call is placed to
clean the cooktop you will be charged for
the visit.
Spillovers of liquid with high sugar
content.
• Y ou touched 2 or more sensor fields at
the same time.
• The Stop+Go function operates.
• T here is water or fat stains on the
control panel.
You put something on one or more
sensor fields.
You put something on the sensor field.
The cooking zone is not hot because it
operated only for a short time.
The cooking zone is hot.
The highest heat setting is set.
The Power management is activated.
remedy
Use a ceramic glass cleaner such as Cerapol.
These types of spills must be removed
immediately with a special scraper for the
glass. If not permanent damage to the
cooktop glass can occur which is not covered
under warranty.
Activate the appliance again and set the heat
setting in less than 10 seconds.
Touch only one sensor field.
Refer to the chapter "Operating instructions"
Clean the control panel.
Remove the object from the sensor fields.
Remove the object from the sensor field.
If the cooking zone operated sufficiently long to
be hot, speak to the service centre.
Let the cooking zone become sufficiently cool.
The highest heat setting has the same power
as the Automatic Heat Up function.
Refer to "Power management".