Extension Cords - Drill Master 120 Volt Variable Speed Jigsaw Manual

Extension Cords

1. Grounded tools require a three wire extension cord.
Double Insulated tools can use either
a two or three wire extension cord.
2. As the distance from the supply outlet increases,
you must use a heavier gauge extension cord.
Using extension cords with inadequately sized
wire causes a serious drop in voltage, resulting
in loss of power and possible tool damage.
(See Table A on page 7.)
3. The smaller the gauge number of the wire, the
greater the capacity of the cord. For example,
a 14 gauge cord can carry a higher current
than a 16 gauge cord. (See Table A.)
4. When using more than one extension cord to make
up the total length, make sure each cord contains at
least the minimum wire size required. (See Table A.)
5. If you are using one extension cord for more
than one tool, add the nameplate amperes
and use the sum to determine the required
minimum cord size. (See Table A.)
6. If you are using an extension cord outdoors, make
sure it is marked with the suffix "W-A" ("W" in
Canada) to indicate it is acceptable for outdoor use.
Symbology
Double Insulated
Canadian Standards Association
Underwriters Laboratories, Inc.
VAC
Volts Alternating Current
A
Amperes
n 0 xxxx/min.
No Load Revolutions per Minute (RPM)
Item 69436 For technical questions, please call 1-888-866-5797.
7. Make sure the extension cord is properly wired
and in good electrical condition. Always replace
a damaged extension cord or have it repaired
by a qualified electrician before using it.
8. Protect the extension cords from sharp objects,
excessive heat, and damp or wet areas.
TABLE A: RECOMMENDED MINIMUM WIRE
GAUGE FOR EXTENSION CORDS* (120/240 VOLT)
NAMEPLATE
AMPERES
25´
(at full load)
0 – 2.0 18
2.1 – 3.4 18
3.5 – 5.0 18
5.1 – 7.0 18
7.1 – 12.0 18
12.1 – 16.0 14
16.1 – 20.0 12
* Based on limiting the line voltage drop to five volts at
150% of the rated amperes.
WARNING marking concerning Risk
of Eye Injury. Wear ANSI-approved
safety goggles with side shields.
Read the manual before
set-up and/or use.
WARNING marking concerning
Risk of Hearing Loss.
Wear hearing protection.
WARNING marking
concerning Risk of Fire.
Do not cover ventilation ducts.
Keep flammable objects away.
WARNING marking concerning
Risk of Electric Shock.
Properly connect power cord
to appropriate outlet.
EXTENSION CORD
LENGTH
50´ 75´ 100´ 150´
18 18 18
18 18 16
18 16 14
16 14 12
14 12 10
12 10 -
10 - -
Page 7
16
14
12
12
-
-
-