Video Loss - EverFocus ELR-4 Instruction Manual

5.3.4 Video Loss

Camera: Select the camera you wish to adjust, "Title" will change to the title name of the selected camera.
Enable: Check box to enable Video Loss.
Log: Check box to record video loss events in the log.
Pre-alarm Record: Check box to record several moments before the video loss. (Pre-alarm recording rate
will follow "Normal" frame rate setting)
Buzzer: Check box to enable buzzer when a video loss event occurs.
Email Notify: Check box to enable email notification when a video loss event occurs.
Network Alarm: Check box to send out a network alarm to client PC when video loss occurs. (requires
PowerCon software and setting up Alarm Server in Network Setup menu)
Alarm Output: This will transmit a signal through one of the alarm outputs. It can be set to either "NONE"
(not active) or "1".
Output Type: Output action when alarm is triggered.
Timeout: Alarm output lasts for the set time duration.
Permanent: Alarm will remain active until user presses "Enter" key on front panel.
Transparent: Alarm output continues as long as there is a video loss.
Trans+Timeout: Alarm output continues until event ends, then lasts for the set time duration.
Figure 5-6 Camera Menu – Video Loss
47