Hardware Installation; Desktop Installation - Interlogix IFS ES3001-4P-4T User Manual

Table of Contents

3. Hardware Installation

Before start up

Before your installation, please refer to the followings for your cabling:

10/100/1000Base-T

All 10/100/1000Base-T ports come with Auto-Negotiation capability. They automatically support 1000Base-T, 100Base-TX

and 10Base-T networks. Users only need to plug a working network device into one of the 10/100/1000Base-T ports, and

then turn on the ES3001-4P-4T. The port will automatically runs in 10Mbps, 20Mbps, 100Mbps or 200Mbps and 1000Mbps

or 2000Mbps after the negotiation with the connected device.

Cabling

Each 10/100/1000Base-T ports use RJ-45 sockets -- similar to phone jacks -- for connection of unshielded twisted-pair

cable (UTP). The IEEE 802.3 / 802.3u 802.3ab Fast / Gigabit Ethernet standard requires Category 5 UTP for 100Mbps

100Base-TX. 10Base-T networks can use Cat.3, 4, 5 or 1000Base-T use 5/5e/6 UTP (see table below). Maximum distance

is 100meters (328 feet).

Port Type

10Base-T

100Base-TX

1000Base-T

Any Ethernet devices like hubs/ PCs can connect to the ES3001-4P-4T by using straight-through wires. The

eight-10/100/1000Mbps ports are auto-MDI/MDI-X can be used on straight-through or crossover cable.

To install the Switch on desktop, simply follow the next steps:

Cat 3, 4, 5, 2-pair

Cat.5 UTP, 2-pair

Cat.5/5e/6 UTP, 2-pair

Figure 3-1: Attaching the rubber feet to the Gigabit Ethernet Switch

Cable Type

IFS ES3001-4P-4T User Manual

Connector

RJ-45

Table of Contents