Assembling Sanding Disc; Assembling Lower Cover For Sanding Disc; Assembling Disc Sander Table - Delta 31-460 Instruction Manual

ASSEMBLING
SANDING DISC
1. Make sure sanding disc plate (A) Fig. 9, is clean.
2. Peel backing from sanding disc and press disc (B)
firmly into position all the way around the sanding plate,
as shown in Fig. 9.
ASSEMBLING LOWER
COVER FOR SANDING DISC
1. Assemble the lower cover (A) Fig. 10, to the belt and
pulley guard, using the three 1/2" (12mm) long sheet
metal screws (B).
ASSEMBLING
DISC SANDER TABLE
1. Thread 13/16" (20mm) long socket head screw
(A) Fig. 11, part-way into threaded hole in base of sander
and insert rod (B) into hole as shown. Rod (B) should
extend 5 inches outside base. Align flat on rod (B) with
screw (A) and tighten screw (A) to hold rod (B) in place.
2. Slide table assembly (C) Fig. 12, onto rod (B) as
shown.
3. Thread 13/16" (20mm) long socket head screw
(D) Fig. 12, into hole in table support bracket as shown.
Align flat on rod (B) with screw (D) and tighten screw (D).
4. WARNING: TO AVOID TRAPPING THE WORK
OR FINGERS BETWEEN THE TABLE AND SANDING
DISC, THE TABLE EDGE (E) FIG. 12, SHOULD BE PO-
SITIONED A MAXIMUM OF 1/16" AWAY FROM
SANDING DISC (F). LOOSEN SCREW (D) AND
ADJUST TABLE ACCORDINGLY.
B
A
A
F
8
A
Fig. 9
B
Fig. 10
B
Fig. 11
B
D
Fig. 12
E
C