Sign in today to find solutions:

Don't have an account? Sign up

Delta 31-750 User Manual [Page 6]: Adjusting Table

Delta sander user manual.

   
ASSEMBLING ABRASIVE
DISCS TO DISC PLATE
IMPORTA N T:M A K E C E R TAIN T H E MACHINE I S DIS-
C O N N E C T E D F R O M TH E P O W E R SOURCE.
There are two types of 9
the sander: hook and loop, and adhesive-backed abra-
sive discs.
H O O K A N D L O O P
If you are using the hook and loop backed abrasive disc,
simply position hook and loop abrasive disc (A) F i g . 4 ,
directly onto disc plate pad (B).
P R E S S U R E SENSITIVE ADHESIVE (PSA)
1 . IMPORTA N T:If you are using the pressure sensitive
adhesive-backed abrasive disc, you must first apply tran-
s i t i o n pad (C) Fig. 5, to disc plate pad (B).
2 . Remove backing (D) Fig. 6, from abrasive disc (E)
and press the disc onto transition pad (C).

ADJUSTING TABLE

IMPORTA N T:Before operating the sander, t h e table
surface must be positioned so it is slightly lower than the
sanding disc.
1 . Place a straight edge (A) Fig. 7, on abrasive disc (B)
and check to see if the disc is slightly higher than the
t able surface (C). NOTE: Check the table height directly
over two adjustment screws (D) Fig. 7, and again over
screws (E).
abrasive discs available for
B
C
D
A
C
6
A
F i g . 4
C
B
F i g . 5
E
D
F i g . 6
E
B
E
F i g . 7
D
Next page -> <- Previous page

Comments to this Manuals

Symbols: 0

Latest comments:

×

Select the desired size and copy embed code

Copy your embed code and put on your site: