Automatic Line Feed System - Flymo Speedi Trim Original Instructions Manual

How the automatic line feed works (J)
1. When initially switching on the trimmer, a small
length of line is fed out.
2. A ʻclatteringʼ noise will be heard when the nylon
line hits the line cutter. DO NOT BE ALARMED
this is quite normal. After approximately 5 sec-
onds the line will be cut to the correct length and
the noise will reduce as the motor reaches full
speed.
• Make sure the motor is up to full speed before
trimming.
3. If the noise of the nylon line being cut cannot be
heard, more line will need to be fed out.
4. To feed more line, it is first necessary to to allow
the motor to stop completely, then re-start, allow-
ing the motor to reach full speed.
5. Repeat step 4. until you hear the line hitting
against the cutter. (Do not repeat this procedure
more than 6 times)
6. If problems are experienced with the automatic
line feed refer to Fault Finding Chart.
To manually feed the nylon line (K)
1. If required line can be fed out manually.
2. To operate, press and release manual line feed
button, whilst gently pulling on one of the lines
until the line reaches the line cutter.
3. When the required amount of line is fed out, gently
pull on the second line (there is no need to press
the manual line feed button again).
4. If the line extends past the line cutter, too much
line has been fed out.
5. If too much line is fed out, remove the spool cap
and click spool anti-clockwise until the line is at
the desired length.
To remove spool cap
1. Press and hold in the two cap release latches. (L).
2. Pull cap away from the spoolholder. (L).
When refitting the spool cap
1. Keep all areas of the cap and spoolholder clean.
Failure to do so may prevent the cap being se-
curely located in the spoolholder.
2. Replace the cap, pressing firmly DOWN towards
the spoolholder to ensure cap is fully located.
3. Check that the cap is correctly fitted by trying to
remove it without depressing the two latches.
To replace nylon line.
For your convenience it is recommended you buy
spool and line complete. Nylon line only is also
available. Both are available from Husqvarna UK
Ltd. stockists.

Automatic Line Feed System

J
K
Manual line
feed button
L
Spool
Spoolholder
Line cutter
Cap
Cap release
latch
Eyelet