Automatic Line Feed System - Flymo Minitrim ST Original Instructions Manual

Hide thumbs Also See for Minitrim ST:
Table of Contents

Advertisement

M
Line lock
hole
N
P
Manual line
feed button
Q
Spool
Spoolholder
To replace nylon line on spool
1. Take approximately 5 metres of line line and insert into
2. Wind line onto spool in the direction of the arrows on
3. Leave approximately 100mm of line unwound and feed
4. Replace spool into spoolholder.
• Ensure spool is correctly fitted.
• Remember! Your trimmer is designed to use only nylon

Automatic Line Feed System

How the automatic line feed works (N)
1. When initially switching on the trimmer, a small length
2. A 'clattering' noise will be heard when the nylon line
• Make sure the motor is up to full speed before trimming.
3. If the noise of the nylon line being cut cannot be heard,
Line cutter
4. To feed more line, it is first necessary to to allow the
5. Repeat step 4. until you hear the line hitting against the
6. If problems are experienced with the automatic line
To manually feed the nylon line (P)
1. If required line can be fed out manually.
2. To operate, press and release manual line feed button,
3. When the required amount of line is fed out, gently pull
Cap
4. If the line extends past the line cutter, too much line
5. If too much line is fed out, remove the spool cap and click
Cap release
latch
To remove spool cap
1. Press and hold in the two cap release latches. (Q).
2. Pull cap away from the spoolholder. (Q).
When refitting the spool cap
1. Keep all areas of the cap and spoolholder clean.
Eyelet
2. Replace the cap, pressing firmly DOWN towards the
3. Check that the cap is correctly fitted by trying to
To replace nylon line.
For your convenience it is recommended you buy spool
and line complete. Nylon line only is also available. Both
are available from Husqvarna UK Ltd. stockists.
one of the line lock holes in the spool (M).
the top of the spool. Care should be taken to ensure
that the line is neatly coiled on the spool (M).
through slot in spoolholder (L).
line with a maximum diameter of 1.5mm. Use only gen-
uine Husqvarna UK Ltd. nylon line.
Always return the product to its normal operating posi-
tion before switching on.
of line is fed out.
hits the line cutter. DO NOT BE ALARMED this is quite
normal. After approximately 5 seconds the line will be
cut to the correct length and the noise will reduce as
the motor reaches full speed.
more line will need to be fed out.
motor to stop completely, then re-start, allowing the
motor to reach full speed.
cutter. (Do not repeat this procedure more than 6 times)
feed refer to Fault Finding Chart.
whilst gently pulling on one of the lines until the line
reaches the line cutter.
on the second line (there is no need to press the
manual line feed button again).
has been fed out.
spool anti-clockwise until the line is at the desired length.
Failure to do so may prevent the cap being securely
located in the spoolholder.
spoolholder to ensure cap is fully located.
remove it without depressing the two latches.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Minitrim auto xtMinitrim auto st

Table of Contents