Schumacher Electric SC-10030A Owner's Manual page 11

Automatic battery charger
Hide thumbs Also See for SC-10030A:
Table of Contents

Advertisement

Available languages

Available languages

Battery Type Button
Use this button to set the type of battery to be charged.
Regular
– Set the button to STANDARD. This battery type is usually used
in cars, trucks and motorcycles. These batteries have vent caps and are
often marked "Low Maintenance" or "Maintenance-free". This type of battery
is designed to deliver quick bursts of energy (such as starting engines)
and have a greater plate count. The plates will also be thinner and have
somewhat different material composition. Regular batteries should not be
used for deep cycle applications.
Deep-Cycle
– Set the button to STANDARD. Deep-cycle batteries are
usually marked as "Deep-Cycle" or "Marine". Deep-cycle batteries are
usually larger than the other types. This type of battery has less instant
energy but somewhat greater long-term energy delivery than regular
batteries. Deep cycle batteries have thicker plates and can survive a
number of discharge cycles.
AGM
– Set the button to AGM. The Absorbed Glass Mat construction
allows the electrolyte to be suspended in close proximity with the plate's
active material. In theory, this enhances both the discharge and recharge
efficiency. Actually, the AGM batteries are a variant of Sealed VRLA (valve
regulated lead acid) batteries. Popular uses include high performance
engine starting, power sports, deep cycle, solar and storage battery. AGM
batteries are typically good deep cycle batteries, and they deliver best
life performance if recharged before the battery drops below a 50 percent
charge. If these AGM batteries are completely discharged, the cycle life
will be around 300 cycles. This is true of most AGM batteries rated as deep
cycle batteries.
GEL
– Set the button to GEL CELL. The Gel Cell is similar to the AGM style
because the electrolyte is suspended, but different because technically the
AGM battery is still considered to be a wet cell. The electrolyte in a Gel Cell
has a silica additive that causes it to set up or stiffen. The recharge voltages
on this type of cell are lower than the other styles of lead acid battery.
This is probably the most sensitive cell in terms of adverse reactions to
over-voltage charging. Gel Batteries are best used in VERY DEEP cycle
application and may last a bit longer in hot weather applications. If the
incorrect battery charger is used on a Gel Cell battery, poor performance
and premature failure is certain.
Battery Size Button
Use this button to set the maximum charge rate to one of the following:
Small Battery:
small batteries such as those commonly used in garden tractors, snow
mobiles and motorcycles. The 2A rate is not intended to be used as a trickle
charger for larger batteries.
Large Battery:
provides 12 amps continuous, depending on the battery. Use for charging
medium to large capacity batteries. Not intended for industrial applications.
Engine Start:
Provides 100 amps for cranking an engine with a weak or run
down battery. Always use in combination with a battery.
Provides a charge rate of up to 2A. Intended for charging
Automatically switches between 12 and 30 amps or
7

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sc-8020a

Table of Contents