Daewoo DTC-29M5ME Service Manual page 7

ALIGNMENT INSTRUCTIONS
SVC KEY EXPLAIN
(S5) BCL THD : MAX BEAM CURRENT ADJUST,DIFFERENT DATA FOR INCH.
BCL GAIN : AVERAGE BEAM ADJUST.
(S6) GEOMETRY : PAL (50Hz) adjust.
(S10) NORMAL : PICTURE NORMAL data setting.
(SLEEP) : TXT CHECK ON LINE
(SIZE) : GAME FUNCTION CHECK ON LINE
(S11) OPTION
- HOTEL VOLUME : HOTEL MODE MAX VOL DATA SETTING
- HOTEL MODE OFF : ON--> VOL MAX SET& INSTALL DONT OPERATING
* Software option for Function Change
PIP (ON)
Digital EYE (ON)
LARGE (OFF)
TEXT sel. (OFF)
2.The confirmation of Protection circuit
Protection circuit confirmation is omitted in case of mass production in the factory
2-1. Over Current Protecor (OCP) circuit confirmation
2-1-1. Receive PAL RETMA PATTERN(signal of company:2CH., PAL-B) and adjust
STANDARD MODE in PICTURE.
2-1-2. Connect 1M
PROTECTOR.
The next place, to confirm normal operation when the resister(1M ) is removed.
2-1-3. After Main Power Switch OFF/ON, to confirm normal operation of picture and sound
when turn the set on by remocon.
AV NTSC is auto correction.
- ON : With PIP Models (xxxxME/MP seiese)
- OFF : Without PIP Models (xxxxMT/MZ seriese)
- ON : Enable the Digital Sensor (DTC-29M5xx, KR29M5-xx)
- OFF : Disable the Digital Sensor (DTC-29U1xx, DTC-29U5xx)
- ON : For 29 inch Models CM-907/F
- OFF : For 14~21
LATIN : English,French,Swedish,Czech,German,Spanish,Italian,Estonian
EAST: English,Slovakian,Hungarian,Serbian,Albanian,Polish,Turkian,Rumanian
RUSSIA : English,Russian,Bulgaian,Ukrainian,Serbian,Montenegro
PERSIAN : English,Farsi
ARAB : English,Arabic
OFF : Teletext Language depends on OSD Language selection
Note : If OSD language & text selec. is different then Teletext depends on Text selec.
1/2W between BASE of Q801 and GND,
inch Models CM-907S
-6-
to confirm operating of