Table of Contents
Advertisement
Personnel should not be exposed to the microwave energy which may radiate from the
magnetron or other microwave generating devices if it is improperly used or connected. All input
and output microwave connections, waveguides, flanges and gaskets must be secured. Never
operate the device without a microwave energy absorbing load attached.
Never look into an open waveguide or antenna while the device is energized.
This Manual has been prepared to provide Service Engineers with Operation and Service Information.
It is recommended that service engineers carefully study the entire text of this manual, so they will be
qualified to render satisfactory customer service.
WARNING
Note:
WARNING
Never operate the oven until the following points are ensured.
(A) The door is tightly closed.
(B) The door and oven hinges are not defective.
(C) The door packing is not damaged.
(D) The door is not deformed or warped.
(E) There is not any other visible damage with the oven.
Servicing and repair work must be carried out only by trained
Service Engineers.
All the parts marked "*" on schematic diagrams are used at
voltages more than 250V.
Removal of the outer wrap gives access to potentials above
250V.
If the Magnetron are damaged may cause undue microwave
exposure.
SOI 05.06 FV
CAUTION
MICROWAVE RADIATION
GENERAL IMPORTANT INFORMATIONS
The parts marked "*" are used at voltage
more than 250V. (Schematic Diagrams).
CAUTION
4/34
599 36 78-44
Hide quick links:
Advertisement
Table of Contents
