Function Of Important Components - Electrolux MC2660E (EU) Service Manual

FUNCTION OF IMPORTANT COMPONENTS

DOOR OPEN MECHANISM
The door can be opened by pushing the door open button.
MONITORED LATCH SWITCH (SW1)
1. When the oven door is closed, the contacts
(COM - NO) must be closed.
2. When the oven door is opened, the contacts
(COM - NO) must be opened.
MONITOR SWITCH (SW2)
1. When the oven door is closed, the contacts
(COM - NC) must be opened.
2. When the oven door is opened, the contacts
(COM - NC) must be closed.
3. If the oven door is opened and the contacts
(COM - NO) of the monitored latch switch
(SW1) fail to open, fuse F8A blows
simultaneously with closing the contacts
(COM - NC) of the monitor switch (SW2).
STOP SWITCH (SW3)
1. When the oven door is closed, the contacts
(COM - NO)must be closed.
2. When the oven door is opened, the contacts (COM - NO) must be opened.
CAUTION: BEFORE REPLACING A BLOWN FUSE (F1 AND F2) TEST THE MONITORED LATCH
SWITCH (SW1) AND MONITOR SWITCH (SW2) FOR PROPER OPERATION.
(REFER TO CHAPTER "TEST PROCEDURE".)
THERMAL CUT-OUT 125
The thermal cut-out located on the top of the oven cavity is designed to prevent damage to the oven if the
foods in the oven catch fire due to over heating produced by improper setting of cook time or failure of control
unit. Under normal operation, the oven thermal cut-out remains closed. However, when abnormally high
temperatures are reached within the oven cavity, the oven thermal cut-out will open at 125°C, causing the oven
to shut down. The defective thermal cut-out must be replaced with a new
THERMAL CUT-OUT 125
This thermal cut-out protects the magnetron against overheat. If the temperature goes up higher than 125
because the fan motor is interrupted or the ventilation openings are blocked, the thermal cut-out TC02 will open
and line voltage to the high voltage transformer T will cut off and operation of the magnetron MG will be
stopped. The defective thermal cut-out must be replaced with a new one.
TURNTABLE MOTOR
The turntable motor drives the turntable roller assembly to rotate the turntable.
FAN MOTOR
The fan motor drives a blade which draws external cool air. This cool air is directed through the air vanes
surrounding the magnetron and cools the magnetron. This air flows through the oven cavity to remove steam
and vapours given off from the heating foods. It is then vented through the exhaust air vents at the rear of oven
cavity.
NOISE FILTER
The noise filter prevents the radio frequency interference that might flow back in the power circuit.
SOI 05.06 FV
°
C TC01 (OVEN)
°
C TC02 (MG)
DOOR
LATCH HOOK
LATCH
HEADS
DOOR OPEN BUTTON
Figure D-1. Door Open Mechanism
one.
14/34
MONITOR
SWITCH (SW2)
MONITORED
LATCH
SWITCH (SW1)
STOP
SWITCH
SW3
OPEN LEVER
°C
599 36 78-44