Preparing Your Camera For Use; Installing The Batteries - BenQ C1020 User Manual

2

Preparing Your Camera for Use

2.1

Installing the batteries

You can use two AA batteries to power up the camera.
Make sure that the power of the digital camera is off
before removing the batteries.
To insert the batteries:
1. Make sure the camera is turned off.
2. Open the battery cover.
3. Insert the batteries in the correct direction as
shown in the illustration.
4. Close the battery cover.
To remove the batteries:
1. Make sure the camera is turned off.
2. Hold the camera with the battery cover facing upward, and then open the battery cover.
3. Remove the batteries.
•
Please select the correct battery type before use. (see "Battery Type" on page 15 for
details).
•
High-capacity (such as 2500 mAh) rechargeable batteries are recommended.
•
Carbon-zinc batteries are not recommended.
•
Remove the batteries from the camera if you do not intend to use the camera for a long
time.
•
If the lens cannot retract into the camera, please replace the batteries first (usually this is
because of drained batteries). Then the lens should retract automatically. (Under no
circumstances should you push the lens back manually as this may damage the camera.)
If the lens still cannot retract, please contact your dealer.
•
The AA batteries that came with the camera are not rechargeable.
4 Preparing Your Camera for Use