Icom IC-F3161DT Instruction Manual page 12

2
PANEL DESCRIPTION
ZONE KEY "ZONE"
Push this key, then push [CH Up] or [CH Down] to select
the desired zone. When [Rotary selector] selects "operating
zone," this key operation is not available.
What is "zone"?— Selected channels are assigned to a
zone according to how they are to be used in a group. For
example, 'Staff A' and 'Staff B' are assigned into a "Busi-
ness" zone, and 'John' and 'Cindy' are assigned into a "Pri-
vate" zone.
ZONE UP AND DOWN KEYS "ZNUP" "ZNDN"
Push to select an operating zone. When [Rotary selector] se-
lects "operating zone," this key is not available.
SCAN KEY "SCAN"
➥ Push to start and cancel scanning operation.
• When Power ON Scan function is activated, push to pause the
scanning operation. And the paused scan restarts after the
specified time period has passed.
➥ Push and hold this key for 1 sec. to indicate the scan list,
then push [CH Up] or [CH Down] to select the desired list.
7
SCAN ADD/DEL (TAG) KEY "SCAD"
➥ Push to add channel to, or delete it from the current scan
group.
1. Push to indicate the scan group, then push [CH Up] or
[CH Down] to select the desired group.
2. Push to add or delete the channel to/from the selected
scan group.
3. Push and hold for 1 sec. to exit the scan group selection
mode.
➥ Push this key while scan is paused (a signal is detected)
on a channel (except for priority channel,) the channel is
cleared from the scan group.
Depending on the setting, the cleared channel is added
to the scan group again after the scan is cancelled.
(Nuisance Delete function)
PRIORITY CHANNEL KEYS "PRA" "PRAR" "PRB" "PRBR"
➥ Push to select Priority A or Priority B channel.
➥ Push and hold [Prio A (Rewrite)] or [Prio B (Rewrite)] for
1 sec. to rewrite the Priority A or Priority B channel for the
operating channel.