GE JCAS745 Owner's Manual And Installation Instructions page 30

Cleaning the glass cooktop.
Glass surface – potential for permanent damage.
Sugary spillovers (such as
jellies, fudge, candy, syrups)
or melted plastics can cause
pitting of the surface of your
cooktop (not covered by the
warranty) unless the spill is
removed while still hot.
Special care should be
taken when removing hot
substances.
Be sure to use a new, sharp
razor scraper.
Do not use a dull or nicked
blade.
30
(on some models)
Metal Marks and Scratches
1
Be careful not to slide pots and pans
across your cooktop. It will leave metal
markings on the cooktop surface.
These marks are removable using the
Ceramic Cooktop Cleaner with the
Cleaning Pad for Ceramic Cooktops.
Cooktop Seal
To clean the cooktop seal around the
edges of the glass, lay a wet cloth on
it for a few minutes, then wipe lcean
with nonabrasive cleaners.
Damage from Sugary Spills and Melted Plastic
1
Turn off all surface units. Remove hot
pans.
2
Wearing an oven mitt:
a. Use a single-edge razor blade
scraper to move the spill to a cool
area on the cooktop.
b. Remove the spill with paper towels.
3
Any remaining spillover should be left
until the surface of the cooktop has
cooled.
To order Parts
To inquire about purchasing a part or an
accessory for your appliance, please call
our toll-free number:
National Parts Center
www.GEAppliances.ca
2
If pots with a thin overlay of
aluminum or copper are allowed to
boil dry the overlay may leave black
discoloration on the cooktop.
This should be removed immediately
before heating again or the
discoloration may be permanent.
WARNING:
bottom of pans for roughness that would
scratch the cootop.
4
NOTE:
surface has already occurred, the cooktop
glass will have to be replaced. In this case,
service will be necessary.
Ceramic Cooktop Cleaner
Ceramic Cooktop Scraper
Kit
.............................................. # WB64X5027
1-800-661-1616
(Kit includes cream and cooktop scraper)
Cleaning Pads for
Ceramic Cooktops
Carefully check the
Don´t use the surface units again
until all of the residue has been
completely removed.
If pitting or indentation in the glass
....... # WX10X300
....... # WX10X302
.................... # WX10X350