GE JCAS745 Owner's Manual And Installation Instructions page 27

Care and cleaning of the range.
Surface unit
Receptacle
Drip pan
Surface Units
(on some models)
Be sure all the controls are turned to OFF and
the surface units are cool before attempting to
remove them.
To clean the surface units, turn the control
to the highest setting for a minute. The coils
will burn off any soil.
To remove a surface unit:
To remove the drip pans for cleaning, the
surface units must be removed first.
Lift the surface unit about 1 inch above the
drip pan and pull it out.
Do not lift the surface unit more than 1". If you
do, it may not lie flat on the drip pan when you
plug it back in.
Repeated lifting of the surface unit
more than 1 inch above the drip pan can
permanently damage the receptacle.
Drip Pans
(if included)
Remove the surface units. Then lift out
the drip pans.
Place them in a covered container. Add
¼ cup ammonia and let soak several
hours or overnight. Wash rinse well
and dry.
The drip pans may also be cleaned in
the dishwasher.
To replace a surface unit:
Replace the drip pan into the recess in the
cooktop. Make sure the opening in the pan
lines up with the receptacle.
Insert the terminals of the surface unit
through the opening in the drip pan and
into the receptacle.
Guide the surface unit into place so it rests
evenly.
Do not immerse the surface units in
liquids of any kind.
Do not clean the surface units in a
dishwasher.
Do not bend the surface unit plug
terminals.
Do not attempt to clean, adjust or in
any way repair the plug-in receptacle.
Clean the area under the drip pans often.
Built-up soil, especially grease, may catch fire.
Do not cover the drip pans with foil. Using foil
so close to the receptacle could cause shock,
fire or damage to the range.
Do not clean the drip pans in a
NOTE:
self-cleaning oven.
27