Installing Transmitter Batteries - Traxxas Slayer Pro 4WD 5908 Owner's Manual

InSTAllInG TRAnSMITTER BATTERIES

Your TQ transmitter uses 8 AA batteries. The battery compartment is
located in the base of the transmitter.
1. Remove the battery compartment door by pressing the tab and
lifting the door up.
2. Install the batteries in the correct orientation as indicated in the
battery compartment.
3. Reinstall the battery door and snap it closed.
4. Turn on the transmitter and check the power indicator for a
solid red light.
If the power indicator light flashes, then the transmitter batteries are
weak, discharged or possibly installed incorrectly. Replace with new or
freshly charged batteries. The power indicator light does not indicate
the charge level of the RX Power Pack installed in the model.
The Traxxas TQ Radio System
InSTAllInG REcEIvER BATTERIES
The radio receiver in your model uses 4 AA batteries.
The battery holder for the receiver batteries is
located underneath the battery cover. The battery
cover can be identified by the on/off switch.
1. Access the battery compartment by removing the
4x12mm and 4x20mm buttonhead cap screws
from the chassis. Swing out the nerf bar just far
enough to clear the battery compartment cover.
2. Remove the battery holder and install 4 AA
alkaline batteries. Make careful note of the battery
polarity by comparing against the diagrams in the
battery holder.
3. Insert the battery holder into the battery compartment.
4. Reinstall the battery cover and secure with the screws.
To prevent losing control of your model, it is important to stop at the first
sign of weak receiver batteries to avoid losing control. Visible warning
signals include sluggish steering response and shortened radio range.
Traxxas TRX Power System (optional)
The optional Traxxas TRX Power System can be purchased
separately to power the radio system in the Slayer. Benefits
include the economy of a rechargeable 5-cell nickel metal
hydride (NiMH) battery pack that replaces AA alkaline
batteries, and increased voltage for dramatically improved
servo performance. The TRX Power Charger (Part #3030X)
is a peak detecting unit that will charge the RX Power
Pack (Part #3036 flat pack or #3037 hump pack) in about one hour. The peak
detection circuitry automatically shuts off the charger when the maximum
charge has been achieved. The TRX Power Charger also includes a 7.2V adapter
for charging 7.2V EZ-Start batteries. The TRX Power Charger can operate on
either AC or DC power. A special wiring harness for Slayer (Traxxas part #3034)
that includes a handy external charging jack is required.
The optional DC car adapter (Part #3032) features a tangle-free,
extra long wire and integrated fuse. The long charging cord
allows the model to remain outside the car while charging.
Caution! Never charge batteries in an enclosed car interior
or while driving. Never leave charging batteries unattended.
Monitor them closely.
Traxxas' integrated TRX Power System is the easiest way to add the power and
economy of rechargeable batteries to your Slayer. Consult your hobby dealer
for purchasing information.
Use the Right Batteries
Your transmitter uses AA
batteries. Use new alkaline
batteries, or rechargeable
batteries such as NiCad
or NiMH (Nickel Metal
Hydride) batteries in your
transmitter. Make sure
rechargeable batteries are
fully charged according to the
manufacturer's instructions.
If you use rechargeable
batteries in your
transmitter, be aware
that when they begin
to lose their charge, they lose
power much more quickly than
regular alkaline batteries.
Caution: Discontinue running
your Slayer at the first sign of
weak batteries (flashing red
light) to avoid losing control.
If the power indicator doesn't
light red, check the polarity
of the batteries. Check
rechargeable batteries for a
full charge.
Slayer • 11