Setting Up The Antenna - Traxxas Slayer Pro 4WD 5908 Owner's Manual

Spray a little window cleaner
on the antenna wire to make
it easier to push through the
antenna tube.
Don't shorten the length of
the antenna wire. Its length
is tuned to the frequency
band; cutting it could
severely shorten the radio
system's range.
Don't push the transmitter
antenna down from the
top. Pull it down from the
bottom, one segment at a
time, to prevent binding and
kinking the antenna mast.
12 • Slayer
The Traxxas TQ Radio System

SETTInG UP ThE AnTEnnA

1. Locate the black antenna wire that exits the receiver. Route the
receiver antenna through the radio box lid and then slide the
antenna wire through the antenna tube.
2. Secure the lid to the radio box with a body clip and then slide an
antenna cap over the end of the antenna tube while leaving the
antenna wire exposed.
3. Insert the antenna tube into the mounting post. Slide the crimp
nut over the antenna tube and screw it onto the antenna post.
Use the supplied tool to tighten the crimp nut on the post just
until the antenna tube is securely in place. Do not over tighten.
Antenna Tip
Antenna Tube
Antenna
Wrench
Antenna
Nut