Table of Contents
Advertisement
WARNING: FIRE HAZARD!
Users of Lithium Polymer (LiPo) batteries must read the
Warnings and Precautions beginning on page 4. ONLY use
the supplied Traxxas iD® LiPo balance charger to charge the included
Traxxas iD® battery. DO NOT charge LiPo batteries with a NiMH-only
charger. The use of a NiMH or NiCad charger or charge mode will
damage LiPo batteries and may cause fire, personal injury, and/or
property damage.
CHARGING THE BATTERY PACK
The supplied Traxxas iD® charger is a fully featured high-output LiPo
balance charger. It features Traxxas iD technology to deliver the perfect
charge with no guesswork. The charger is equipped with a universal
USB-A plug for convenient charging almost anywhere.
1
1
Plug the charger into a USB-A port.
Minimum 2 amp, 5V DC output recommended
Power on
2
2
Connect the battery to begin charging.
Battery connected
LED flashes green while charging
3
3
Battery connected
LED solid green when charging is complete
!
!
INSTALLING TRANSMITTER BATTERIES
Your TQ 2.4GHz transmitter uses 4 AA batteries. The battery
compartment is located in the base of the transmitter.
1. Remove the battery compartment door by pressing the tab
and sliding the door open.
2. Install the batteries in the correct orientation as indicated in
the battery compartment.
Connect battery
www.modellmarkt24.ch
TRAXXAS TQ RADIO SYSTEM
Disconnect the battery when charging is complete.
Battery connected
Important! If the
Solid red and no green or flashing red LED
battery is damaged
with a battery connected indicates an error
or defective, the
charger's green
LED will not come
on and the red LED
will glow solid or
flash. Disconnect
the battery. DO NOT
attempt to charge
the battery.
4 AA Alkaline
The supplied charger is
designed for use only with the
included Traxxas 2-cell LiPo iD
battery. DO NOT attempt to
charge other LiPo batteries or
any other type of battery with
this charger.
2,3
2,3
TRX-4M • 13
Advertisement
Table of Contents
