Security - Raymarine Dragonfly Installation And Operation Instructions Manual

Removing the safety latch
If you want to use a third party security lock to secure the display
to the cradle then the Safety Latch must be removed.
1
1. Releasing safety latch retaining ring.
2. Removing safety latch and retaining ring.
With the Safety Latch in the unlocked position:
1. Remove the display from the cradle.
2. Insert the end of a small flat blade screwdriver between the
gap in the retaining ring.
3. Gently lever the retaining ring apart and over the safety latch.
The safety latch and retaining ring should be kept in case
required for future use.
Mounting
2
D13040-1

4.5 Security

The display can be locked into the bracket using a proprietary
lock i.e. the Thule 544 lock (not supplied).
The Thule 544 lock is available from retail outlets.
Note:
• It is strongly recommended that the lock is adequately
maintained to prevent the lock from corrosion and seizure.
• Raymarine does not guarantee the security of your display
when using a lock.
• Raymarine will not be held liable for any damage caused to
the display or cradle due to the use of a lock.
Locking hole location
If a lock is to be fitted to the display to secure it to the cradle
then the blanking plug must be removed.
1. Cradle Down locking hole location.
2. Cradle Up locking hole location.
Depending on display variant the unit may be fitted in the cradle
in the cradle down orientation. When mounting in the cradle
down orientation, the blanking plug should be moved to cover
the exposed hole as shown below.
1. Cradle Up position.
2. Cradle Down position.
Fitting the lock
With the display mounted in the cradle:
1. Remove the plastic cap that covers the cradles locking hole.
1
D12635-2
1
Dxxxxx-1
D13038-1
27