Clarion MAX67SVD Owner's Manual & Installation Manual page 27

Basic Operations
Changing the output speaker for the
cellular phone
• The factory default setting is "RIGHT".
• To output the telephone calls, set the above
TEL SWITCH item to "ON".
3-1. Touch the
[~J
key to display the next menu
screen.
3-2. Touch the [LEFT] or [RIGHT] key of the TEL
SP item to set to "LEFT" or "RIGHT".
LEFT:
Telephone calls are heard from the left
speaker connected to this unit.
RIGHT:
Telephone calls are heard from the right
speaker connected to this unit.
Note:
• During cellular phone interrupts, setting this
function is disabled.
Setting the anti-theft function
(CATS)
"CATS" is the acronym of "Clarion Anti-Theft
System".
When you set a PIN code (called as "Personal
Code"), a theft is prevented by disabling the
operation of the unit at the theft.
In addition, set the BUNK LED function in the
GENERAL menu to [ON] to improve the effect of
the CATS function (see page 26).
Setting your Personal Code
1. Press the [ADJ] button, then touch the
[GENERAL] key.
2. Keep pressing the [MENU] button more than
2 seconds.
The SET PERSONAL CODE screen appears.
Note:
• When a Personal Code
is
already set, the ERASE
PERSONAL CODE screen will appear. Retry this
operation after erasing the old Personal Code.
3. Enter your desired 4-digit Personal Code by
touching the [0] to [9] keys, then touch the
[ENT] key.
*
Touch the [CLR] key when you make a
mistake in entering.
Note:
• Write down your Personal Code in case you forget
it.
4. Enter the same Personal Code again for
confirmation, then touch and hold the [ENT]
key for more than 2 seconds.
The entered Personal Code will be set, and it
will return to the previous screen.
Erasing the Personal Code
1. Press the [ADJ] button, then touch the
[GENERAL] key.
2. Keep pressing the [MENU] button more than
2 seconds.
The ERASE PERSONAL CODE screen
appears.
3. Enter the Personal Code currently set by
touching the [0] to [9] keys, then touch and
hold the [ENT] key for more than 2 seconds.
The message "CODE ERASED" appears,
and it will return to the previous screen.
When~eENTERPERSONALCODE
screen appears
The ENTER PERSONAL CODE screen will be
displayed when turning the ACC power on after
performing the following operations:
• The car battery was replaced.
• The backup power was cut off.
• The [RESET] button was pressed.
Note:
• If you have lost your Personal Code, please
contact Clarion customer service at 800-347-8667.
1. Enter your Personal Code currently set.
2. When the correct Personal Code is entered,
the unit will restart from the initial startup
screen.
Note:
• When you enter a wrong Personal Code, the
message "CODE INCORRECT" is displayed and
the Personal Code entry
is
prohibited for a while.
This prohibited time is changed according to the
number of times of wrong code entry as follows:
• 1 to 6 times: 15 seconds
• 7 times or more: 15 minutes
MAX675VD
27