Impex MARCY SM 4000 Owner's Manual page 15

STEP 8 (See Diagram 8 & Cable Loop)
A.) Attach the 132" Lower Cable (#40) to the opening on the bottom of the Rear Vertical Beam
(#6). Attach a Pulley to the opening. Attach two Pulley Bushings (#62) to the holes outside
of the opening. Attach the Foot Plate (#16) to the Bushings. Align the holes and secure
them with one M10 x 3 3/8" Allen Bolt (#73), two Ø ¾" Washers (#66), and one M10
Aircraft Nut (#86).
B.) Draw the Cable underneath the Pulley to the open bracket on the Weight Glide Base (#8).
Install a Pulley with a M10 x 1 ¾" Allen Bolt (#69), two
Aircraft Nut (#86). Draw the Cable around the Pulley then upward to the Double Floating
Pulley Bracket previously installed in Step-6. Install another Pulley.
C.) Draw the Cable around the Pulley then downward to the open bracket on the Rear Vertical
Beam. Install another Pulley.
D.) Draw the Cable around the Pulley and upward to the Single Floating Pulley Bracket
previously installed in Step-7. Connect the Cable to a Short Chain (#63) by using a C-clip
(#61). Attach the Short Chain to the Bracket. Secure it with a M10 x 1" Allen Bolt (#68), two
Ø ¾" Washers (#66), and one M10 Aircraft Nut (#86). Adjust the tension of the Cable by
adjusting the length of the Chain.
E.) Secure the Foot Plate (#16) to the Weight Glide Base (#8) with two M10 x 1" Allen Bolts
(#68), four Ø ¾" Washers (#66), and two M10 Aircraft Nuts (#86).
F.) Connect the Long Chain (#64) to the Lower Cable with a C-clip. For various exercises,
connect with one of the Shiver Bar (#30), V Bar (#88), Ankle Strap (#89), Single Handle
Strap (#90), or the Triceps Rope (#91) with a C-clip.
14
3/4" Washers (#66) and one M10