Impex MARCY SM 4000 Owner's Manual page 13

STEP 6 (See Diagram 6 & Cable Loop)
A.) Attach the 132" Upper Cable (#41) to the front opening on the Upper Frame (#9). Attach a
Pulley (#57) to the opening. Secure it with one M10 x 2 ½" Allen Bolt (#70), two Pulley
Bushings (#62), and one M10 Aircraft Nut (#86). Make sure the ball stopper of the Cable is
underneath the Frame.
B.) Draw the Cable over the Pulley along the Upper Frame to the opening on the rear of Upper
Frame. Attach a Pulley to the opening. Secure it with one M10 x 2 ½" Allen Bolt (#70), two
Pulley Bushings (#62), and one M10 Aircraft Nut (#86).
C.) Draw the Cable around the Pulley then downward. Install a Pulley in between the two Double
Floating Pulley Brackets (#18). Secure the Pulley with one M10 x 1 ¾" Allen Bolt (#69), two Ø
¾" Washers (#66), and one M10 Aircraft Nut (#86). Let the Bracket hanging for now.
D.) Draw the Cable around the Pulley then up to the open bracket on the top of the Weight Glide
Post (#7). Attach a Pulley to the bracket. Secure it with one M10 x 3" Allen Bolt (#71), two Ø
¾" Washers (#66), and one M10 Aircraft Nut (#86).
E.) Draw the Cable around the Pulley then down to the Sliding Weight Post (#14). Secure the
Cable to the Sliding Weight Post with one M10 x 1" Allen Bolt (#68), two Ø ¾" Washers (#66),
and one M10 Aircraft Nut (#86).
F.) Connect the Lat Bar (#29) to the Upper Cable with a Short Chain (#63) and two C-Clips (#61).
G.) Attach two Olympic Sleeves (#43) to the weight posts on the Sliding Weight Post. Attach two
Spring Clips (#60) to the Sleeves.
12