Engaging The Blades - Troy-Bilt Super Bronco Operator's Manual

Engaging the Blades

Engaging the PTO (Blade Engage) transfers power to the cutting
deck or other (separately available) attachments. To engage the
blades, proceed as follows:
1. Move the throttle control lever to the FAST (rabbit)
position.
2. Grasp the PTO (Blade Engage) lever and pivot it all the way
forward into the engaged (ON) position.
3. Keep the throttle lever in the FAST (rabbit) position for the
most efficient use of the cutting deck or other (separately
available) attachments
IMPORTANT:
The engine will automatically shut off if the PTO
is engaged with the shift lever in position for reverse travel with
the ignition key in the NORMAL MOWING position. Refer to
Safety Interlock Switches earlier in this section.
Using the Deck Lift Lever
To raise the cutting deck, move the deck lift lever to the left, then
place it in the notch best suited for your application. Refer to
Setting The Cutting Height earlier in this section.
Mowing
WARNING:
thrown object injury, keep bystanders, helpers,
children and pets at least 75 feet from the machine
while it is in operation. Stop machine if anyone
enters the area.
The following information will be helpful when using the cutting
deck with your tractor:
WARNING:
discharge of materials toward roads, sidewalks,
bystanders and the like. Also, avoid discharging
material against a wall or obstruction which may
cause discharged material to ricochet back toward
the operator.
• Do not mow at high ground speed, especially if a mulch kit
or grass collector is installed.
• For best results it is recommended that the first two laps be
cut with the discharge thrown towards the center. After the
first two laps, reverse the direction to throw the discharge
to the outside for the balance of cutting. This will give a
better appearance to the lawn.
• Do not cut the grass too short. Short grass invites weed
growth and yellows quickly in dry weather.
• Mowing should always be done with the engine at full
throttle.
• Under heavier conditions it may be necessary to go back
over the cut area a second time to get a clean cut.
• Do NOT attempt to mow heavy brush and weeds and
extremely tall grass. Your tractor is designed to mow lawns,
NOT clear brush.
• Keep the blades sharp and replace the blades when worn.
Refer to Cutting Blades in the Maintaining Your Lawn
Tractor section of this manual for proper blade sharpening
instructions.
16 16 s s 5— O 5— O
ectiOn ectiOn peratiOn peratiOn
To help avoid blade contact or a
Plan your mowing pattern to avoid
Headlights
• The lamps are ON whenever the ignition key is moved out
of the STOP position.
• The lamps turn OFF when the ignition key is moved to the
STOP position.
NOTE: On models using the four-position key switch, the
headlights will be activated when the key is moved into the Run/
Lights position. See Fig. 4-3B in the Controls & Features section
for an illustration of the lights-on position on all four-position
key switch models.