Table of Contents
Advertisement
Controls
The collision warning is available even if cruise
control has been deactivated.
When the vehicle is intentionally brought close
to a vehicle, the collision warning is delayed to
avoid false warnings.
General information
The system issues a two-phase warning of a
danger of collision with vehicles at speeds
above approx. 3 mph/5 km/h. The time of these
warnings may vary depending on the current
driving situation.
Up to approx. 35 mph/60 km/h a braking inter‐
vention occurs when appropriate.
Detection range
Vehicles are observed when they are traveling
in the same direction of movement if they are
located within the detection range of the sys‐
tem.
At a glance
Button in the vehicle
110
Safety
Online Edition for Part no. 01 40 2 910 949 - VII/13
Intelligent Safety button
Switching on/off
Some Intelligent Safety systems are automati‐
cally active after each engine start via the start/
stop button.
Press the button:
A panel appears on the Control Dis‐
play. Adjustments can be made. The individual
settings are stored for the remote control cur‐
rently in use.
Press the button briefly:
▷
Intelligent Safety systems are indi‐
vidually switched off according to
individual setting.
▷
LED lights up orange or goes out depend‐
ing on the individual setting.
Press the button again:
▷
All Intelligent Safety systems are switched
on.
▷
The LED lights up green.
Hold the button down:
▷
All Intelligent Safety systems are
switched off.
▷
The LED goes out.
Setting the warning time
The warning time can be set via iDrive.
These settings have no effect on the time of
the warning when the system prompts the
driver to intervene or brake.
1.
"Settings"
2.
"Frontal Coll. Warning"
3.
Activate the desired warning time on the
Control Display.
Advertisement
Table of Contents
