Yamaha FZ1-N Service Manual page 67

1. Clutch cable
2. Left handlebar switch lead
3. Main switch lead
4. Immobilizer lead
5. Horn lead
6. Horn stay assembly
7. Throttle cable (pull side)
8. Throttle cable (return side)
9. Wire harness
10.Brake hose
11.Throttle cables
12.Right handlebar switch lead
A. Wire is connected to the meter.
B. Route the stay assembly above central
cable guide.
C. After branching the lead from the left han-
dlebar switch, route it under the stay
assembly and upper guide wire (from the
vehicle front side to the rear side).
D. Route the stay assembly below central
cable guide.
E. Clamp the horn lead to the stay assembly.
Position the binding section in front of the
vehicle body and cut the tip to be between
2 to 4mm (0.08 to 0.16in).
F. Clamp the wire harness at the place of the
white tape and insert it to the stay assem-
bly. Point the clamp opening to the outside
of the vehicle.
G. Lay on the front brake light switch lead
above the throttle cables.
H. Secure the brake hose to the front fork.
I. Secure the horn lead to the front fork. Cut
the tip of the clamp head leaving 2 to 4mm
(0.08 to 0.16in) toward the outside of the
vehicle.
J. The center position of the clamp shall be
within this numeric range.
K. The outside of the vehicle.
L. The inside of the vehicle.
M. Pass the brake hose in the space by the
right side of the vehicle from this wire and
pass the throttle cables and right handle-
bar switch lead in the left side space. Next,
route the right handlebar switch lead to the
vehicle rear side where the throttle cables
are routed.
2-40
CABLE ROUTING