Installation Warnings; Packing List; Items Packed With The Face; Order Of Installation - Travis Industries Green Smart Owner's Manual

Installation (for qualified installers only)

Installation Warnings

 Failure to follow all of the requirements may result in property damage, bodily
injury, or even death.
 This heater must be installed by a qualified installer who has gone through a
training program for the installation of direct vent gas appliances.
 The installation must conform with local codes or, in the absence of local
codes, with the National Fuel Gas Code, ANSI Z223.1/NFPA 54, or the National
Gas and Propane Installation Code, CSA B149.1.
 In Manufactured or Mobile Homes must conform with Manufactured Home
Construction and Safety Standard, Title 24 CFR, Part 3280, or, when such a
standard is not applicable, the Standard for Manufactured Home Installations,
ANSI/NCSBCS A225.1. This appliance may be installed in Manufactured
Housing only after the home is site located.
 The heater is designed to operate on natural gas, or propane (LP).
 All exhaust gases must be vented outside the structure of the living-area.
Combustion air is drawn from outside the living-area structure.
 Notify your insurance company before hooking up this heater.
 The requirements listed below are divided into sections. All requirements
must be met simultaneously. The order of installation is not rigid – the
qualified installer should follow the procedure best suited for the installation.

Packing List


Propane Conversion Kit (Orifices, Manifold Cover,
etc.)

Cove Covers

Items Packed with the Face


Face with attachment hardware (Note: use the cove covers included with the heater)

Face Installation Instructions

Order of Installation

1 If the heater is to use propane, install the propane conversion kit (see page 43).
2 Install gas line into the fireplace (do not connect to unit).
3 Position the heater and connect the electrical line.
4 Connect the gas line and gas vent to the appliance.
5 Install the optional surround panels and trim.
6 Install the burner and media (logs or stones).
7 Follow the instructions under "Finalizing the Installation" on page 25.
© Travis Industries

"Fireplace Altered" tag (attach to the fireplace)

Plugs for Surround Panels

Remote Control

Cover Plate for Receiver (with screws)
4120301
7
100-01286_000