Label Application; Ride-On Rocker - Fisher-Price 73528 Instructions Manual

Assembly
Assembly
21
Trike
Handle
Cover
Base/Handle
• Position the base/handle covers so that the flared end
faces the front of the trike.
• Fit the base/handle covers onto the trike rear frame near
the rear wheels.
• Insert two #10 x 3 / " screws through each base/handle
4
cover and into the base/handle. Tighten the screws with a
Phillips screwdriver. Do not over-tighten.
Assembly is now complete.

Label Application

Label Application
Handle
Center of Label
• Before applying the label, wipe the surface of the
handle with a clean, dry cloth to remove any dust or oils.
• Remove the backing from the label.
• First, position the center of the label on the handle,
as shown. Then, smooth each end of the label outward
to attach it to the handle.
• For best results, avoid repositioning a label once it has
been applied to the handle.
Flared End
Place Center
of Label Here

Ride-on Rocker

Ride-on Rocker
IMPORTANT! Be sure to adjust the seat in the most forward
position for Ride-on Rocker mode.
Wheel Retainer
• Insert the base/handle pin through one wheel retainer, a
hole in the front wheel and into the other wheel retainer.
• Push the handle pin to "snap" it into place. Pull on the
handle pin to be sure it is secure.
9 9
Base/Handle Pin
Front Wheel
Wheel Retainer