Guide Bar And Saw Chain Combinations; Saw Chain Filing And File Gauges - Jonsered CS 2245 II Operator's Manual

Jonsered chain saw

Hide thumbs Also See for CS 2245 II:

Operator's manual (76 pages)

Operator's manual (40 pages)

Operator's manual (36 pages)

Table Of Contents

Table of Contents

Recommended cutting equipment for USA

Following is a list of recommended cutting equipment for Jonsered chain saw models CS 2245 II, CS 2245S II and CS

2250S II. These chain saw models equipped with either of the listed guide bar and saw chain combination(s), fulﬁlls the

requirements according to ANSI B175.1-2000 (Gasoline Powered Chain Saws - Safety Requirements).

The following list is the chain saw manufacturers recommendations. There may be other combinations available, which

will also achieve kickback reduction.

Chain saw models Jonsered CS 2245 II, CS 2245S II and CS 2250S II met the kickback performance requirements of

ANSI B 175.1-2000 when tested with the combinations of bars and saw chains listed below. The saw chain Jonsered

H30 is also classiﬁed as a low kickback saw chain since it met the requirements for low kickback saw chain outlined in

ANSI B 175.1-2000. We recommend to use only the listed combinations of bars and chains for chain saw models

Jonsered CS 2245 II, CS 2245S II and CS 2250S II. Other chain saw models may not meet the kickback requirements

when equipped with the listed bar and chain combinations.

Kickback information

The guide bar nose radius is determined by either the maximum number of teeth in the nose sprocket or the

corresponding maximum nose radius of a solid bar.

As we are listing the maximum guide bar nose radius, you may use a guide bar with smaller nose radius than in our list.

For guide bars of the same length, all sprocket-nose guide bars of the same pitch and having the same number of

sprocket teeth may be considered to have equivalent kickback energy.