Fisher-Price Ramps Around Garage B1832 Instructions Manual page 4

5
• "Snap" the tabs on the lower track into the slots in
the base.
6
• Press the clamp on the track support onto the
base column.
• Rotate the track support so that the holes in the
support fit over the pegs on the lower track.
Lower Track
Column
Clamp
Track Support
Pegs Through Holes
Assembly
Upper Track
7
• Place the garage on its side on a flat surface, as shown.
• "Snap" the rectangular connectors on the upper track into
the holes at the top of the base.
• Fit the other end of the upper track over the end of the
lower track.
• Place the garage upright again.
1 /
• Insert two
the upper track, as shown. Tighten the screws.
Channel
Slot
8
• Tip the elevator handle and fit the hooked tab through the
channel in the side of the elevator
• Slide the elevator handle down and "snap" the tab on the
handle into the slot in the elevator
4
"
screws into the holes on the underside of
2
Hooked Tab
Elevator
Handle
.
.