Advertisement
Elevator Upper Tabs
1
Bottom Slots
• Position the elevator on a flat surface. Note the locations
of the bottom slots and the upper tabs on the elevator.
• Hold the base at an angle. While making sure the upper
tabs on the elevator fit into the grooves in the base
insert the tabs on the base into the bottom slots on the
elevator
.
• Press down on the base to "snap" the elevator in place.
2
• Fit the elevator roof on the elevator.
• Insert four #6 x 1" screws into the elevator roof and tighten.
Base Grooves
Tabs
Elevator Roof
Assembly
Ramp
3
,
• Place the garage on its side on a flat surface, as shown.
• Fit the connectors on the end of the ramp into the holes
on the top of the base. Be sure to fit the hooked tab on
the side of the elevator into the slot on the ramp. Press
the ramp until it "snaps" in place.
• Place the garage upright again.
Diagnostic Center
4
• Slide and "snap" the
diagnostic center into
the base.
• Turn the base over and insert two
base. Tighten the screws.
• Turn the base upright.
3
Slot
Hooked Tab
Bottom View
1
/
"
screws into the
2
Advertisement
