Assembly; Fitting The Loop Handle; Assembling The Cutting Equipment; Fitting The Trimmer Guard And Auto 32 Trimmer Head - Jonsered GR 2026 L Operator's Manual

Fitting the loop handle

• Unscrew the knob and plastic cover from the handle
mounting.
• Place the loop handle and handle holder on the handle
mounting. Fit the knob and plastic cover. Do not
overtighten.
• Put on the shoulder strap and hang the trimmer from the
support hook. Now make a final adjustment so that the
trimmer is in a comfortable working position when it hangs
from the shoulder strap. Tighten the knob.
10 –
English

ASSEMBLY

Assembling the cutting equipment

!
!
Fitting the trimmer guard and Auto
32 trimmer head
• Fit the correct trimmer guard (A) for use with the trimmer
head. Secure the trimmer guard using the 4 screws (L)
and the support plate (M) as shown.
• Fit the drive disc (B) on the output shaft.
• Turn the blade shaft until one of the holes in the drive disc
aligns with the corresponding hole in the gear housing.
• Insert the locking pin (C) in the hole to lock the shaft.
• To fit the trimmer head, first separate the two halves (see
diagram). Proceed as follows:
• Insert a finger into the centre hole of the cover (I) while
grasping the cover with your other fingers. Using the index
finger and thumb of your other hand, release the two
catches (J) that engage in the cut-outs in the bottom half
(K). Pull apart the trimmer head, grasping the cover firmly.
• Place the cover (I) and the support flange (F) on the
output shaft.
WARNING!
When fitting the cutting attachment it is
extremely important that the raised section
on the drive disc/support flange engages
correctly in the centre hole of the cutting
attachment. If the cutting attachment is fitted
incorrectly it can result in serious and/or
fatal personal injury.
WARNING! Never use a cutting attachment
without an approved guard. See the chapter
on Technical data. If an incorrect or faulty
guard is fitted this can cause serious
personal injury.
G
F
K
I
M
J
L
I
A
K
B
C