Error Messages; No-Beep Symptoms - Lenovo Edge 11 Hardware Maintenance Manual

Error messages

Table 3. Error messages
Symptom or error (beeps, if any)
Bad CRC2. Enter BIOS Setup Utility, and load Setup
defaults.
(two short beeps)
Fan error.
(four short beeps, one long beep)
DRAM is unplugged.
(one short beep, pause, three short beeps, pause, three
short beeps, pause, one short beep.)
DRAM is not well plugged.
(one short beep, pause, three short beeps, pause, three
short beeps, pause, one short beep.)
Operating system not found.
System Configuration Data Read Error
(two short beeps)

No-beep symptoms

Table 4. No-beep symptoms
Symptom or error
No beep, power-on indicator on, LCD blank, and no
POST.
No beep, power-on indicator on, and LCD blank during
POST.
The power-on password prompt appears.
The hard-disk password prompt appears.
50
ThinkPad Edge 11" and E10 Hardware Maintenance Manual
FRU or action, in sequence
Press F1 to enter BIOS Setup Utility. Press F9, and
Enter to load the default setting. Then save the current
setting by pressing F10, and restart the computer.
1. Fan.
2. Thermal grease.
3. System board.
Memory card is not installed. Install memory card.
Reinstall the memory card.
1. Check that the operating system has no failure and
is installed correctly.
2. Enter BIOS Setup Utility and see whether the hard disk
drive is properly identified. If you still see the same
error message, check the boot sequence.
3. Reinstall the hard disk drive.
4. Reinstall the operating system.
Press F1 to enter BIOS Setup Utility. Press F9, and
Enter to load the default setting. Then save the current
setting by pressing F10, and restart the computer.
FRU or action, in sequence
1. Make sure that every connector is connected
tightly and correctly.
2. DIMM.
3. System board.
1. Reseat DIMM.
2. System board.
A power-on password or a supervisor password is set.
Type the password and press Enter.
A hard-disk password is set. Type the password and
press Enter.