Zanussi ZWH 7120 P User Manual page 9

Tie the plastic hose guide to the tap with a
string to prevent that the drain hose unhooks
when the appliance is emptying.
• Onto a sink outlet spigot.
Push the drain hose onto the spigot and se-
cure with a clip, ensure a loop is formed in
the drain hose to prevent waste from the sink
entering the appliance.
If the outlet spigot has not been used before,
remove any blanking plug that may be in
place.
• Directly into a drain pipe at a height of
not less than 60 cm and not more than
100 cm.
www.zanussi.com
If your drain hose
looks like this (see
beside) you do not
require the "U"
piece". Just push the
hose firmly in to the
standpipe.
• Directly to a built-in drain pipe in the
room wall.
The drain hose may be extended to a maxi-
mum of 4 metres. An additional drain hose
and joining piece is available from your Local
Centre.
The end of the drain
hose must always be
ventilated, i.e. the
inside diameter of the
drain pipe must be
larger than the out-
side diameter of the
drain hose. The drain
hose must not be
kinked.
9