Zanussi ZWH 7120 P User Manual page 27

Fault code and malfunc-
tion
Door open
The appliance does not start or stops during
operation without any visible alarm.
Malfunction
The appliance does not
start:
The appliance fills then
empties immediately:
The appliance does not
empty and/or does not
spin:
There is water on the
floor:
www.zanussi.com
The door has not been closed or is not closed properly.
• Close firmly the door.
The plug is not properly inserted in the power socket.
• Insert the plug into the power socket.
There is no power at the socket.
• Please check your domestic electrical installation.
The main fuse has blown.
• Replace the fuse.
The programme selector dial is not correctly positioned and the button 9 has
not been pressed.
• Please turn the selector dial and press the button 9 again.
The delay start has been selected.
• If the laundry are to be washed immediately, cancel the delay start.
The Child Safety Lock has been activated.
• Deactivate the Child Safety Lock.
The end of the drain hose is too low.
• Refer to paragraph in "Water drainage" in chapter "Installation".
An option or a programme that ends with the water still in the tub or a that
eliminates all the spinning phases has been selected.
• Select the draining or spinning programme.
The laundry is not evenly distributed in the drum.
• Redistribute the laundry.
Too much detergent or unsuitable detergent (creates too much foam) has
been used.
• Reduce the detergent quantity or use another one.
Check whether there are any leaks from one of the inlet hose fittings. It is not
always easy to see this as the water runs down the hose; check to see if it is
damp.
• Check the water inlet hose connection.
The drain or inlet hose is damaged.
• Replace it with a new one.
Possible cause / Solution
Before contacting your local Service Centre,
please carry out the checks listed below.
Possible cause / Solution
27