User Specified Intercharacter Delay; Interfunction Delay - Honeywell Vuquest 3310g User Manual

To remove this delay, scan the Intercharacter Delay bar code, then set the
number of delays to 0. Scan the Save bar code using the
Chart inside the back cover of this manual.
Note: Intercharacter delays are not supported in USB serial.

User Specified Intercharacter Delay

An intercharacter delay of up to 5000 milliseconds (in 5ms increments) may
be placed after the transmission of a particular character of scanned data.
Scan the Delay Length bar code below, then scan the number of 5ms
delays, and the Save bar code using the
back cover of this manual.
Next, scan the Character to Trigger Delay bar code, then the 2-digit hex
value for the ASCII character that will trigger the delay
Chart (Code Page 1252),
Delay Length
To remove this delay, scan the Delay Length bar code, and set the number
of delays to 0. Scan the Save bar code using the
inside the back cover of this manual.

Interfunction Delay

An interfunction delay of up to 5000 milliseconds (in 5ms increments) may
be placed between the transmission of each control character in the mes-
sage string. Scan the Interfunction Delay bar code below, then scan the
number of 5ms delays, and the Save bar code using the
Chart inside the back cover of this manual.
4 - 6
beginning on page A-4.
Prefix Scanned Data
STX 1 HT
Interfunction Delays
Interfunction Delay
Programming Chart
Character to Trigger Delay
Suffix
2 3 4 5 CR
Programming
inside the
ASCII Conversion
Programming Chart
Programming
LF