Preferred Symbology Default; Output Sequence Overview; Output Sequence Editor; To Add An Output Sequence - Honeywell Vuquest 3310g User Manual

bar code has been encountered. Scan the bar code below, then set the
delay (from 1-3,000 milliseconds) by scanning digits from the inside back
cover, then scanning Save. Default = 500 ms.

Preferred Symbology Default

Scan the bar code below to set all Preferred Symbology entries to their
default values.

Output Sequence Overview

Output Sequence Editor

This programming selection allows you to program the scanner to output
data (when scanning more than one symbol) in whatever order your appli-
cation requires, regardless of the order in which the bar codes are
scanned. Reading the Default Sequence symbol programs the scanner to
the Universal values, shown below. These are the defaults. Be certain
you want to delete or clear all formats before you read the Default
Sequence symbol.
Note: To make Output Sequence Editor selections, you'll need to know the
code I.D., code length, and character match(es) your application
requires. Use the Alphanumeric symbols (inside back cover) to read
these options. You must hold the button while reading each bar code
in the sequence.

To Add an Output Sequence

1. Scan the Enter Sequence symbol (see
Sequence, page 3-26).
2. Code I.D.
On the Symbology Charts
want to apply the output sequence format. Locate the Hex value for that
symbology and scan the 2 digit hex value from the Programming Chart
(inside back cover).
3. Length
Specify what length (up to 9999 characters) of data output will be
acceptable for this symbology. Scan the four digit data length from the
Preferred Symbology Time-out
Preferred Symbology Default
on page A-1, find the symbology to which you
Require Output
3 - 23