Oven Door Removal - Wolf 30" (762) Installation Manual

Gas Range Installation

Oven Door Removal

IMPORTANT NOTE: Remove the oven door(s) only if it is
necessary to fit the range through a tight doorway.
Removal may cause damage to the porcelain oven interior
or the door(s). Door removal should be done by a qualified
service technician or installer.
For removal, a hinge pin (supplied with the range) must be
inserted in the appropriate hinge arm. For each oven door,
only one hinge arm is spring loaded, requiring use of the
hinge pin for removal of the oven door. The hinge pin can
be found taped to the inside of the oven door.
For single oven ranges, the hinge pin will be inserted
through the hole in the right hinge arm (facing the range).
For double oven ranges, the spring hinges are located on
the outer edges of the unit. The left oven door will have
the spring hinge on the left side and the right oven door
will have the spring hinge on the right side. Refer to the
illustrations below.
Failure to insert the hinge pin in the appropriate hinge
arm will cause damage to the range.
SPRING HINGE
Single oven ranges.
SPRING HINGES
Double oven ranges.
OVEN DOOR REMOVAL
1) Remove the lower kickplate assembly.
2) Open the oven door all the way and insert the door
hinge pin through the hole in the appropriate hinge
arm. Refer to the illustration below.
3) Remove both upper and lower hinge retainer mounting
screws. The oven gasket may have to be moved
slightly to access the bottom screws.
4) Move the hinge retainer plate forward slightly. The
hinge retainer plate will remain on the door hinge after
the mounting screws have been removed.
5) Carefully close the oven door to approximately 60°
from horizontal and lift the door away from the oven.
A slight racking motion may be required for removal.
Do not lift or carry the oven door by the door handle.
HINGE
RETAINER UPPER
PLATE MOUNTING
SCREW
HINGE
PIN
KICKPLATE
Oven door removal.
15
wolfappliance.com/specs