Whirlpool WHES45 Installation And Operation Manual page 28

28
3. Symbols in the display indicate POSITION switch operation.
Switch is closed
(Cam rotating)
4. Use the RECHARGE button to manually advance the valve into each cycle and check correct
switch operation.
5. Press the DATA button again. The following information is available and may be beneficial for
various reasons. This information is retained by the computer from the first time electrical power
is applied to the face plate.
a. The top half of the display shows the total number of recharges since the timer was connected
to electrical power.
b. The bottom half of the display shows the number of days since the timer was connected to
electrical power. If over 1999 days, a (x 10) indicator shows, meaning you must multiply the
number shown times 10.
6. Press DATA once again to return the present time to the display.
On
LAST RECHARGE
WATER MANAGEMENT SYSTEM
TURBINE
RECHARGE
WATER MANAGEMENT SYSTEM
Fill
TIME
WATER MANAGEMENT SYSTEM
TURBINE
Switch is open
(cam not rotating)
x 10
DAY