Heater Back Cover Kit Installation - Paloma PRS-150N Owner's Manual And Installation Instructions

Room sealed gas space heaters

Table of Contents

The heater back cover kit is supplied with the heater. The back cover kit attaches to the rear of the heater and the top

cover rear edge is located over the two back cover kit wall brackets (to locate and mount back cover kit wall brackets

refer to the installation instructions supplied with the flue kit).

Sideways and under floor installations require an Extra Wide Back Cover Kit (kit PWSK001) which is utilised instead

of the standard back cover kit supplied with the heater.

STANDARD BACK COVER KIT CONTENTS (Supplied with Heater)

* PRS-250CN and PRS-250CL commercial models only.

EXTRA WIDE BACK COVER KIT CONTENTS (Kit PWSK001 – For Sideways & Underfloor Installations)

STANDARD BACK COVER KIT INSTALLATION

Warnings:

Warning: Before installing the back cover kit, ensure the heaters exhaust tube and air intake hose are firmly

connected.

Warning: Ensure that nothing (including air intake hose) is in contact with metallic parts of the heaters exhaust

tube. Reposition telescopic exhaust tube insulating sock if required.

Procedure:

Align LH side cover screw hole over hole in heater

lower bracket and insert cover location tab into heater

side slot.

Fasten LH side cover to lower bracket with hexagon

bolt.

Align RH side cover screw hole over hole in heater

lower bracket and insert cover location tab into heater

side slot.

Fasten RH side cover to lower bracket with hexagon

bolt.

Align top cover over top of LH & RH side covers and

the two wall brackets.

Fasten top cover to side covers with hexagon bolts.