Table of Contents
Advertisement
INSTALLATION
The following points must also be observed:
•
DO NOT install this heater in areas where spray painting occurs or in areas where there may be lots of fluff, dust
or airborne particles such as in hairdressers, workshops etc.
•
DO NOT install on an uneven surface unless the heater can be levelled by adjusting the heaters height
adjustable feet.
•
DO NOT install under shelves or in a confined space. Note: This heater is not suitable as a fireplace insert and
must not be built into walls, cupboards bookcases etc.
•
DO NOT install where the heater may receive splashing water or near another heat source.
•
DO NOT connect to an LPG gas cylinder located indoors.
•
DO NOT connect the heater to double adapters or power boards. The heater must be directly connected to a
240 Volt 10 Amp GPO.
•
DO NOT install under a power point.
Also refer to the installation instructions supplied with the flue kit for important information on flue location.
MINIMUM & MAXIMUM ROOM SIZES
PRS Series Room Sealed Gas Space Heaters do not have a minimum room size requirement because they are room
sealed heaters that discharge combustion products to an external position via the flue system.
PRS Series Room Sealed Gas Space Heaters should not to be installed in a room larger than the specified maximum
room size. Although the heater can be installed in a room larger than the specified maximum room size the maximum
heating capacity of the heater will be exceeded and the heater may not be able to reach or be able to maintain the set
temperature.
Specified Maximum Room Size by Heater Model (room length X width)
PRS-150N/L
PRS-250N/L
PRS250CN/L
(1)
Based on a maximum ceiling height of 2.7 metres (guide only).
HEATER INSTALLATION PROCEDURE
1.
Determine heater and flue location (refer to "Heater Location" on page 13 and "Flue Location" on page 16).
2.
Install flue kit (refer to the installation instructions supplied with the flue kit). Note: During this step the flue
penetration holes will be cut and the back cover kit mounting brackets fixed to the wall.
3.
Connect heater exhaust (refer to "Connecting Heater Exhaust" on page 21).
4.
Connect heater air intake (refer to "Connecting Heater Air intake" on page 22).
5.
Connect heater gas connection (refer to "Gas Connection" on page 18).
6.
Connect heater electrical connection (refer to "Electrical Connection" on page 19).
7.
Install heater back cover kit (refer to "Heater Back Cover Kit Installation" on page 23).
8.
Commission heater (refer to "Commissioning" on page 25).
Very Cold
2
30 m
2
52 m
2
52 m
Cold
2
35 m
2
61 m
2
61 m
14
(1)
Cool
2
48 m
2
82 m
2
82 m
Mild
2
54 m
2
94 m
2
94 m
Hide quick links:
Advertisement
Table of Contents
