Table of Contents
Advertisement
The electrical installation must comply with AS/NZS 3000, AS/NZS 5601 or AS/NZS 5601.1 and any local
requirements.
This heater is equipped with a 10A 3 pin plug socket which requires a 10 amp general purpose outlet (GPO) that is
connected to a 240V AC 50 Hz M.E.N. (multiple earthed neutral) mains power supply.
The GPO should be located in an accessible position beside the heater.
•
The GPO must be located within 1200 mm from the left hand side of the heater or 1600 mm from the right hand
side of the heater to facilitate cord connection without the use of an extension cable.
•
DO NOT connect the heater to double adapters or power boards.
•
DO NOT install the heater under a power point.
WIRING DIAGRAM
ELECTRICAL CONNECTION
19
Hide quick links:
Advertisement
Table of Contents
