Lcd Screen - Sony NXCAM HXR-NX30E Operating Manual

When the lithium battery becomes weak, the

operating distance of the Wireless Remote
Commander may shorten, or the Wireless
Remote Commander may not function
properly. In this case, replace the battery with
a Sony CR2025 lithium battery. Use of another
battery may present a risk of fire or explosion.

LCD screen

Do not apply excessive pressure on the LCD

screen, as it may cause uneven color and other
damage.
If your camcorder is used in a cold place, a

residual image may appear on the LCD screen.
This is not a malfunction.
While using your camcorder, the back of

the LCD screen may heat up. This is not a
malfunction.
To clean the LCD screen
The surface of the LCD screen is coated. If you

scratch the surface, the coating may be come
off. Mind the following points when cleaning
and handling it.
Use a soft cloth (a cloth for glasses, etc.)

gently to clean the dirt.
Remove the dust or sand with a blower, etc.

before wiping the dirt.
The coating may be scratched if you wipe the

screen with a tissue, etc.
If hand grease or hand cream remains on the

screen, the coating comes off more easily.
Wipe it early.
GB
110
On adjustment of the touch panel
([Calibration])
The buttons on the touch panel may not
work correctly. If this happens, follow the
procedure below. It is recommended that
you connect your camcorder to the wall
outlet (wall socket) using the supplied AC
Adaptor during the operation.
  [Setup]  [
Touch
Settings]  [Calibration].

Touch "" displayed on the screen with the
corner of memory card or the like 3 times.
Touch [Cancel] to cancel calibration.
Notes
If you did not press the right spot, try the

calibration again.
Do not use a sharp-pointed object for

calibration. Doing so may damage the LCD
screen.
You cannot calibrate the LCD screen if it is

rotated, or closed with the screen facing out.
On handling the casing
If the casing is soiled, clean the camcorder body

with a soft cloth lightly moistened with water,
and then wipe the casing with a dry soft cloth.
Avoid the following to avoid damage to the

finish:
Using chemicals such as thinner, benzine,

alcohol, chemical cloths, repellent, insecticide
and sunscreen
Handling the camcorder with above

substances on your hands
Leaving the casing in contact with rubber or

vinyl objects for a long period of time
General