Installing The Mounting Bracket - Audiovox AVXMTG13UA Installation Manual

INSTALLING THE MOUNTING BRACKET

Installing the Mounting Bracket
1� Once all the pre-wiring is complete, locate:
• Mounting Bracket
• (4) M4 x 15mm Self-Drilling Screws
2� Carefully align the Mounting Bracket in the location it is to be
installed (make sure there is nothing between the Mounting Bracket
and Roof Cross-Member)�
NOTE: In some vehicles the headliner may need to be cut to install the mounting bracket properly. Use caution to avoid cutting wires above or
attached to the headliner.
Front
of
Vehicle
Mounting Bracket
3� While holding the Mounting Bracket in place, install the
(4) M4 x 15mm Self-Drilling Screws�
CAUTION: Be sure that the Self-drilling Screws do not pierce the
outer roof skin when fully fastened to the Roof Cross-Member�
*
CAUTION: Use extreme caution when using the
Self-drilling Screws to avoid damage to vehicle
roof or other components, wiring, etc.
13
Roof
Roof Cross-Member
Headliner
Mounting Bracket
*
Self-drilling Screws
(4 x Self Drilling
Screws - M4 x 15mm)