Royal RGPRO Owner's Manual page 8

- CHECK to see if hot rod glows red after a couple minutes
o If hot rod does not glow. Unplug grill, and check
fuse on back of control board. NOTE: a spare is
wire tied to the functioning fuse at the connection
point
o If fuse is ok and rod does not get hot, a new HOT
ROD will be needed. Manual lighting of pellets can
be done at owner's discretion.
GRILL FIRE GOES OUT:
- CHECK that supply of pellets has not been interrupted.
- CHECK that pellets are dry and designed for grilling
applications
- CHECK that excessive wind is not affecting burning.
- CHECK Visually verify that auger is turning properly
o Auger not turning: set to high mode and visually
recheck that auger is not turning. If not, unplug grill
and check motor connector plug to see that it is
properly connected (connector with RED wire). If
connections are tight, a new auger drive motor will
be needed.
o Check fan to see if it's spinning. If not, unplug grill
and check fan connector with ORANGE wire to
ensure that it has not come loose. If connection is
tight, turn power back on and check fan. NOT
turning indicates a new fan motor will be needed.