Connecting The Power Cord; Connecting An Ac Power Cord - HP 3600 v2 Series Installation Manual

Figure 26 Ground the switch by burying the grounding conductor into the earth ground
(1) Grounding screw
(4) Joint

Connecting the power cord

CAUTION:
Before powering on the switch, you must connect the power cord and make sure the switch is well
grounded.

Connecting an AC power cord

Follow these steps to connect an AC power cord:
Wear an ESD-preventive wrist strap, and make sure the wrist strap makes good skin contact and
1.
is well grounded.
Insert the plug of the AC power cord into the AC power receptacle (see
2.
Connect the other end of the AC power cord to the AC power source.
3.
Check the power LED (PWR) on the front panel. If the LED is on, the power cord is properly
4.
connected.
Figure 27 Connect the AC power cord
(2) Grounding cable
(5) Grounding conductor
18
(3) Earth
(6) Cassis rear panel
Figure 27).